Very reliable and precise indicator and data transmitter. It can feed up to 6 load cells through a junction box. Available in Modbus RTU as standard. Option of Profibus DP. Set up data can be stored for later replication in the 1008 tester and calibrator.
DAT-500
Technical documentation
- 96x48x120 mm ( L x H x D). Mounting on panel, manhole: 92x44
- Material : ABS
- Protection DAT400(front) : IP-20 DAT500(front): IP-51
- Weight : 230 g
- Working temperature : -10 až +40°C
- Power supply : 24 VDC ± 15%
- Power equirement : 5 W.
- Dislay and setting : 6x 7 segment LED digit, height 1,44 mm -- 4x red status LED --- 4x membrane buttons.
- Conversion response : 50 Hz (without filtration)
- Internal discernment : 60.000 poits
- Sensibility : 0,02 µV/division
- Linearity : < 0,01% on the range
- Temperature effect : < 0,001% on the range/°C
- Converter A/D : 24 bit
- Decimal point : 0,0 - 0,00 - 0,000 optional.
- For 6 load cells (350 Ohmů) 4 or 6 wire
- Output interface RS-232, RS 422 or RS 485.
- 2 digital (logical) input (opto-izolated, 24 VDC PNP - requierement external supply)
- 2 digital output ( semiconductor relay, max. 24VDC/100 mA each)
- 1 analog output (0-10 VDC, max. resistance 10 kOhm or 4-20 mA , min. resistance 300 Ohm)
- Setting possible using buttons on front panel or through RS 232 interface and program INOVATION.
- Both direct or indirect calibration are possible (the second mentioned is suitable for calibration of forces, big containers e.g. which cannot be calibrated directly ).
- Power supply source for DAT 400/500 Mod. 121 is recommended to be used
